#define PIR_PIN 12
#define Led1 18
#define Led2 5
#define Led3 17


void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("Hello, ESP32!");
  pinMode(PIR_PIN, INPUT);
  pinMode(Led1, OUTPUT);
  pinMode(Led2, OUTPUT);
  pinMode(Led3, OUTPUT);

  
}

void loop() {
  // put your main code here, to run repeatedly:
  int estadoPIR = digitalRead(PIR_PIN);
  delay(10);

  if (estadoPIR == HIGH) {  // if there are movements
        digitalWrite(Led1, HIGH);
        digitalWrite(Led2, HIGH);
        digitalWrite(Led3, HIGH);
        Serial.println("Motion detected! LEDs on.");
  } else {                 // if there aren't movements
        digitalWrite(Led1, LOW);
        digitalWrite(Led2, LOW);
        digitalWrite(Led3, LOW);
        Serial.println("No movement. LEDs off.");
  }
  
}