const int buttonPin = 2;  // Define the button connected to digital pin 2
int buttonState;          // Variable to store the button state

void setup() {
  pinMode(buttonPin, INPUT_PULLUP);  // Set the pin as input mode with internal pull-up resistor
  Serial.begin(9600);                // Initialize serial communication
}

void loop() {
  buttonState = digitalRead(buttonPin);  // Read the button state

  if (buttonState == LOW) {  // If the button is pressed (connected to GND)
    Serial.println("Button is pressed");
    Serial.println(digitalRead(2));
  } else {  // If the button is not pressed (high level)
    Serial.println("Button is not pressed");
    Serial.println(digitalRead(2));
  }

  delay(100);  // A short delay to avoid jitter
}