#include <Arduino.h>

// Pin definitions for RGB LED
int redPin = 11;    // Red pin of RGB LED
int greenPin = 10; // Green pin of RGB LED
int bluePin = 9;  // Blue pin of RGB LED

// Pin definitions for regular LEDs
int led1 = 13;
int led2 = 12;
int led3 = A1;


//port tester

int AnalogPin = A0;
float Vin;
int analogVal;


// Pin definitions for potentiometers
const int redPot = A2;   // Potentiometer for red control
const int greenPot = A3; // Potentiometer for green control
const int bluePot = A4;  // Potentiometer for blue control

void setup() {
  // Initialize serial communication
  Serial.begin(9600);
  
  // Set RGB LED pins as outputs
  pinMode(redPin, OUTPUT);
  pinMode(greenPin, OUTPUT);
  pinMode(bluePin, OUTPUT);
  
  // Set regular LED pins as outputs
  pinMode(led1, OUTPUT);
  pinMode(led2, OUTPUT);
  pinMode(led3, OUTPUT);
  
  // Turn on regular LEDs at startup
  digitalWrite(led1, HIGH);
  digitalWrite(led2, HIGH);
  digitalWrite(led3, HIGH);
  
  // Wait 2 seconds
  delay(2000);
  
 
}

void loop() {
  // Read values from potentiometers
  int redValue = analogRead(redPot);
  int greenValue = analogRead(greenPot);
  int blueValue = analogRead(bluePot);
  
  // Debug output
    Serial.println("________________________________________");
  Serial.print("Red: ");
  Serial.print(redValue);
  Serial.print(" Green: ");
  Serial.print(greenValue);
  Serial.print(" Blue: ");
  Serial.println(blueValue);
   Serial.println("________________________________________");
  
  int redPWM =map(redValue, 0, 1023, 0, 255);
  int greenPWM = map(greenValue, 0, 1023, 0, 255);
  int bluePWM = map(blueValue, 0, 1023, 0, 255);
  
  // Write PWM values to RGB LED pins
  analogWrite(redPin, redPWM);
  analogWrite(greenPin, greenPWM);
  analogWrite(bluePin, bluePWM);
  
  // Small delay to stabilize readings
  delay(1000);



analogVal = analogRead(AnalogPin);
  Vin= (analogVal *5.)/1023.;
  Serial.println(Vin);
  delay(500);




}