// https://wokwi.com/projects/428048999353543681
// Code from
// https://github.com/arduino/arduino-examples/blob/main/examples/02.Digital/toneMultiple/toneMultiple.ino
// See also https://forum.arduino.cc/t/wokwi-simulations-for-arduino-built-in-examples/1304754
// (try a delay(10) for better stability, and a lower input limit of 8 for the mapping)
// For low pitches (down to 31Hz), make sure the delay and the duration are long enough
// to cover a cycle before restting a tone. (1000ms/31Hz=33)
// Wokwi sim uses https://docs.wokwi.com/parts/wokwi-photoresistor-sensor
// as the LDR divider 

/*
  Pitch follower

  Plays a pitch that changes based on a changing analog input

  circuit:
  - 8 ohm speaker on digital pin 9
  - photoresistor on analog 0 to 5V
  - 4.7 kilohm resistor on analog 0 to ground

  created 21 Jan 2010
  modified 31 May 2012
  by Tom Igoe, with suggestion from Michael Flynn

  This example code is in the public domain.

  https://docs.arduino.cc/built-in-examples/digital/tonePitchFollower/
*/

void setup() {
  // initialize serial communications (for debugging only):
  Serial.begin(9600);
}

void loop() {
  // read the sensor:
  int sensorReading = analogRead(A0);
  // print the sensor reading so you know its range
  Serial.println(sensorReading);
  // map the analog input range (in this case, 400 - 1000 from the photoresistor)
  // to the output pitch range (120 - 1500Hz)
  // change the minimum and maximum input numbers below depending on the range
  // your sensor's giving:
//  int thisPitch = map(sensorReading, 400, 1000, 120, 1500);
  int thisPitch = map(sensorReading, 8, 1015, 120, 1500);

  // play the pitch:
  tone(9, thisPitch, 10);
  delay(1);  // delay in between reads for stability
}