void setup() {

  int PULSADOR1 = 0;
int PULSADOR2 = 0;
int PULSADOR3 = 
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("Hello, ESP32!");


 #define LED1 2 
  #define LED2 4  
  #define LED3 16
  #define PUL1 12
  #define PUL2 14
  #define PUL3 26
  pinMode(LED1, OUTPUT); 
  pinMode(LED2, OUTPUT); 
  pinMode(LED3, OUTPUT); 
  pinMode(PUL1, INPUT); 
  pinMode(PUL2, INPUT);
  pinMode(PUL3, INPUT_PULLUP);
}

void loop() {
  // put your main code here, to run repeatedly:
 PULSADOR = digitalRead(pul1);
 PULSADOR = digitalRead(pul2);
 PULSADOR = digitalRead(pul3);
 
  if (digitalRead(PUL1)==LOW) 
  digitalRead(LED1, HIGH);

 } else {

 digitalRead(LED1, LOW);
 }
 if (PULSADOR2 == HIGH)



  delay(10); // this speeds up the simulation
}