// Arduino Death Sound - Duh-Duh-Duh-Duh
// Connect buzzer positive to pin 8, negative to GND

const int buzzerPin = 8;

void setup() {
  pinMode(buzzerPin, OUTPUT);
}

void loop() {
  // Play the death sound sequence
  playDeathSound();
  delay(3000);  // Wait 3 seconds before repeating
}

void playDeathSound() {
  // Four descending tones: duh-duh-duh-duh
  
  // First "duh" - highest pitch
  tone(buzzerPin, 440);  // A4 note
  delay(300);
  noTone(buzzerPin);
  delay(100);
  
  // Second "duh" - slightly lower
  tone(buzzerPin, 349);  // F4 note
  delay(300);
  noTone(buzzerPin);
  delay(100);
  
  // Third "duh" - lower still
  tone(buzzerPin, 294);  // D4 note
  delay(300);
  noTone(buzzerPin);
  delay(100);
  
  // Fourth "duh" - lowest, longest for dramatic effect
  tone(buzzerPin, 220);  // A3 note
  delay(600);            // Longer final note
  noTone(buzzerPin);

  delay(1000);

    tone(buzzerPin, 440);  // D4 note
  delay(40);
  noTone(buzzerPin);
  delay(10);
  
  // Fourth "duh" - lowest, longest for dramatic effect
  tone(buzzerPin, 640);  // A3 note
  delay(100);            // Longer final note
  noTone(buzzerPin);
}

// Simple Arduino Buzzer Beep
// Connect buzzer positive to pin 8, negative to GND

//const int buzzerPin = 8;
//
//void setup() {
//  pinMode(buzzerPin, OUTPUT);
//}
//
//void loop() {
//  // Create a short beep
//  tone(buzzerPin, 1000);  // 1000 Hz frequency
//  delay(200);             // Beep for 200ms
//  noTone(buzzerPin);      // Stop the tone
//  delay(2000);            // Wait 2 seconds before next beep
//}