#define led_pin_blue 8 //Declared the pin numbers 
#define led_pin_red 13
#define button_pin_blue 7
#define button_pin_red 15

void setup() {
  Serial.begin(115200); //Use A Serial Monitor
  Serial.println("Hello, ESP32-C6!");
  pinMode(led_pin_blue, OUTPUT); 
  pinMode(led_pin_red, OUTPUT);
  pinMode(button_pin_blue, INPUT_PULLUP);
  pinMode(button_pin_red, INPUT_PULLUP);
}

void loop() {
  // put your main code here, to run repeatedly:
  if(digitalRead(button_pin_blue) == LOW){
    Serial.println("You picked Blue!");
    digitalWrite(led_pin_blue, HIGH);
    delay(1000); //duration of LED ON
    digitalWrite(led_pin_blue, LOW);
  }
  else if(digitalRead(button_pin_red) == LOW){
    Serial.println("You picked Red!");
    digitalWrite(led_pin_red, HIGH);
    delay(1000);
    digitalWrite(led_pin_red, LOW);}
  delay(10); // this speeds up the simulation
}