IDLine 10 Sensors - Wokwi ESP32, STM32, Arduino Simulator

#define LED_PIN 8

void setup() {
  Serial.begin(115200);
  Serial.println("Hello, ESP32-C3!");
  pinMode(LED_PIN, OUTPUT);
}

void loop() {
  digitalWrite(LED_PIN, HIGH);
  delay(500);
  digitalWrite(LED_PIN, LOW);
  delay(500);
}

WHITE : LED SUPER BRIGHT (with pullup Resistor 470 ohm to 5v) BLUE : PHOTODIODE (with pullup Resistor 10k ohm to 3.3v)

Sensor Wiring BLACK : GND YELLOW : S0 (MUX) <-> GPIO3 (ESP32c3) GRAY: S1 (MUX) <-> GPIO2 (ESP32c3) BLUE: S2 (MUX) <-> GPIO8 (ESP32c3) MAGENTA: S3 (MUX) <-> GPIO6 (ESP32c3) CYAN: SIG (MUX) <-> GPIO4 (ESP32c3) ORANGE: VCC (MUX) <-> 3.3v (ESP32c3) RED : 5v

5k1

4k7

10k