from machine import Pin, ADC, I2C
from time import sleep
import dht
from ssd1306 import SSD1306_I2C

#OLED setup
i2c = I2C(0, scl=Pin(22), sda=Pin(21))
oled = SSD1306_I2C(128, 64, i2c)

#Inputs
button = Pin(12, Pin.IN, Pin.PULL_UP)
ldr = ADC(Pin(34))
ldr.atten(ADC.ATTN_11DB)
pot = ADC(Pin(35))
pot.atten(ADC.ATTN_11DB)
sensor_dht = dht.DHT22(Pin(4))
pir = Pin(27, Pin.IN)

#Outputs
led_green = Pin(2, Pin.OUT)
led_yellow = Pin(18, Pin.OUT)
led_red = Pin(5, Pin.OUT)
buzzer = Pin(15, Pin.OUT)

#OLED Display Function
def show_message(line1, line2=""):
    oled.fill(0)
    oled.text(line1, 0, 10)
    oled.text(line2, 0, 30)
    oled.show()

show_message("Smart Learning", "Panel Ready")
sleep(2)

while True:
    # Read sensor values
    light_val = ldr.read()
    pot_val = pot.read()
    pir_val = pir.value()
    button_val = button.value()

    # Temperature + Humidity
    sleep(0.3)
    sensor_dht.measure()
    temp = sensor_dht.temperature()
    hum = sensor_dht.humidity()

    print("LDR:", light_val, "POT:", pot_val, "TEMP:", temp, "HUM:", hum, "PIR:", pir_val)

    # Reset outputs
    led_green.off()
    led_yellow.off()
    led_red.off()
    buzzer.off()

    #Motion Detected
    if pir_val == 1:
        led_yellow.on()
        show_message("Motion Detected", "Student Present")
        sleep(0.5)

    #Light Check
    if light_val > 600:
        led_red.on()
        buzzer.on()
        show_message("Too Dark!", "Increase Light")
        sleep(0.5)
        buzzer.off()

    #Temperature Check
    if temp > 30:
        led_red.on()
        buzzer.on()
        show_message("Too Hot!", f"Temp: {temp:.1f}C")
        sleep(0.5)
        buzzer.off()

    #Potentiometer (Score level)
    if pot_val > 3000:
        led_green.on()
        show_message("Good Job!", "High Score Level")
        sleep(0.5)

    if button_val == 0:
          buzzer.on()
          show_message("Answer", "Project Submitted!")
          sleep(0.5)
          buzzer.off()

    sleep(0.3)