void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("Hello, ESP32!");
}

void loop() {
  // put your main code here, to run repeatedly:
  delay(10); // this speeds up the simulation
}
#include "DHT.h"

#define DHTPIN 2     // Pin connected to the DHT sensor
#define DHTTYPE DHT11   // DHT11 or DHT22

DHT dht(DHTPIN, DHTTYPE);

void setup() {
  Serial.begin(9600);
  dht.begin();
  Serial.println("Temperature & Humidity Logger");
}

void loop() {
  delay(2000); // Wait a few seconds between readings

  float humidity = dht.readHumidity();
  float temperature = dht.readTemperature();

  // Check if any reads failed
  if (isnan(humidity) || isnan(temperature)) {
    Serial.println("Failed to read from DHT sensor!");
    return;
  }

  Serial.print("Humidity: ");
  Serial.print(humidity);
  Serial.print(" %\t");
  Serial.print("Temperature: ");
  Serial.print(temperature);
  Serial.println(" *C");
}