# Code 1:
# MicroPython LED Blink Code for Wokwi
from machine import Pin
import time

# Set GPIO 13 as output
led = Pin(13, Pin.OUT)

# Set GPIO 2 as input (use sw.value() to read its state)
sw = Pin(2, Pin.IN)

while True:
    if sw.value() == 1:     # Check input pin correctly
        led.value(1)        # Turn LED ON
    else:
        led.value(0)        # Turn LED OFF




# Code 2:
"""
from machine import Pin
import time

# Set GPIO 13 as output
led = Pin(13, Pin.OUT)

while True:
        led.value(1)        # Turn LED ON
        time.sleep(1)

        led.value(0)        # Turn LED OFF
        time.sleep(1)

"""

# Code 3:
"""
import RPi.GPIO as GPIO        # Import the Raspberry Pi GPIO library
from time import sleep        # Import sleep function to create delays

GPIO.setmode(GPIO.BOARD)      # Set pin numbering mode to physical pin numbers

GPIO.setup(13, GPIO.OUT)      # Configure pin 13 as an output pin

while True:                  # Create an infinite loop
    GPIO.output(13, True)     # Set pin 13 to HIGH (turn ON the LED)
    sleep(1)                  # Wait for 1 second

    GPIO.output(13, False)    # Set pin 13 to LOW (turn OFF the LED)
    sleep(1)                  # Wait for 1 second
"""

# Code 4:
"""
import RPi.GPIO as GPIO
from time import sleep

GPIO.setmode(GPIO.BOARD)

GPIO.setup(13,GPIO.OUT)
GPIO.setup(2,GPIO.IN)

while True:

    if GPIO.input(2) == GPIO.HIGH:
        GPIO.output(13, True)

    else:
        GPIO.output(13, False)

"""