#include <Wire.h>                   // Library for I2C communication
#include <LiquidCrystal_I2C.h>       // Library for LCD
#include <DHT.h>                     // Library for DHT sensor

// Define pin connections
#define DHT_PIN 2        // DHT22 sensor data pin connected to pin 2
#define MQ2_PIN A0       // MQ-2 gas sensor analog output connected to A0
#define DHT_TYPE DHT22   // Define sensor type

// Initialize LCD with I2C address 0x27, 16 columns, and 2 rows
LiquidCrystal_I2C lcd(0x27, 16, 2);

// Initialize DHT sensor
DHT dht(DHT_PIN, DHT_TYPE);

void setup() {
  Serial.begin(9600);  // Start serial communication at 9600 baud rate
  lcd.init();          // Initialize LCD
  lcd.backlight();     // Turn on LCD backlight
  dht.begin();         // Initialize DHT sensor
  pinMode(MQ2_PIN, INPUT);  // Set MQ-2 gas sensor pin as input
}

void loop() {
  static unsigned long lastSensorRead = 0;

  // Read sensor data every 2 seconds
  if (millis() - lastSensorRead > 2000) {
    float humidity = dht.readHumidity();    // Read humidity from DHT22
    float temperature = dht.readTemperature();  // Read temperature from DHT22
    int gasValue = analogRead(MQ2_PIN);     // Read gas sensor value (Needs Calibration)

    // Display data on LCD
    lcd.clear();
    lcd.setCursor(0, 0);
    lcd.print("T:");
    lcd.print(temperature);
    lcd.print("CH:");
    lcd.print(humidity);
    lcd.print("%");

    lcd.setCursor(0, 1);
    lcd.print("Gas: ");
    lcd.print(gasValue);  // Display raw gas sensor value (Needs Calibration)

    // Print data on Serial Monitor
    Serial.print("Temperature: ");
    Serial.print(temperature);
    Serial.print(" °C, Humidity: ");
    Serial.print(humidity);
    Serial.print("%, Gas Level: ");
    Serial.println(gasValue);

    lastSensorRead = millis();  // Update last sensor read time
  }
}