// Simplified Embedded Rust
// Core Library Edition
// CH5-Q5 Wiring Template

// In the Wokwi components list there exists a PIR motion sensor component that simulates motion.
// The PIR sensor has three pins; a power, ground, and digital output (OUT). Triggering the sensor will
// drive the OUT pin high for 5 seconds, and then go low again. The sensor will ignore any further
// input for the next 1.2 seconds, and then start sensing for motion again. Create a project that upon
// detecting movement turns on a red LED.

#![no_std]
#![no_main]

use esp_backtrace as _;
use esp_hal::{
    delay::Delay,
    gpio::{Io, Level, Output},
    prelude::*,
};

#[entry]
fn main() -> ! {
    // Take the peripherals
    let peripherals =
        esp_hal::init(esp_hal::Config::default());

    // Create a delay handle
    let delay = Delay::new();

    println!("Hello world!");

    loop {
        println!("Loop...");
        delay.delay_ms(500u32);
    }
}